
A garage door is the largest moving object in most Houston homes, and it cycles up and down thousands of times a year in heat, humidity, and the occasional tropical storm. Sooner or later, something gives. The good news is that the same handful of problems account for the vast majority of service calls, and most of them are predictable, fixable, and far cheaper to address early than late.
Below are the eight problems we see most often across Houston, Katy, Pearland, and the surrounding area, ranked roughly by how frequently they come up. For each one you will find the symptoms, the usual cause, whether it is a safe DIY job, and what most homeowners pay to have it fixed in 2026.
1. Broken torsion spring
Symptoms: A loud bang from the garage, then the door will not open (or the opener strains and lifts it only a few inches). You may see a visible gap in the spring above the door.
Cause: Springs are rated for a set number of cycles, usually 10,000 on standard springs. In Houston, humidity and temperature swings accelerate metal fatigue, so many springs fail in 7 to 10 years.
DIY or pro: Pro, no exceptions. Torsion springs are under extreme tension and cause serious injuries every year.
Typical cost: $200 to $450 for parts and labor, depending on door size and whether one or two springs are replaced.
2. Safety sensors misaligned or blocked
Symptoms: The door opens fine but refuses to close, or starts closing and reverses. The opener light may flash, and one sensor LED is blinking or off.
Cause: The photo-eye sensors near the floor have been bumped out of alignment, are dirty, or have a damaged wire. A leaf, a broom, or direct sunlight on the lens can also trip them.
DIY or pro: Often DIY. Wipe the lenses, check that both LEDs are solid, and gently adjust until they are. If the lights will not stay solid or the wire is damaged, call a pro.
Typical cost: Free if you fix it yourself; $75 to $200 for a professional realignment or sensor replacement.
3. Worn or broken rollers
Symptoms: The door is loud, shakes, or moves in jerks. You may see cracked nylon wheels or rollers that wobble on their stems.
Cause: Builder-grade plastic rollers simply wear out, often within 5 to 7 years. Steel rollers without bearings rust in Houston’s humidity.
DIY or pro: Pro. Replacing rollers means working near the springs and cables, and the bottom rollers are under load.
Typical cost: $125 to $275 for a full set of sealed nylon rollers installed.
4. Frayed or snapped cables
Symptoms: The door hangs crooked, one side moves faster than the other, or you see loose cable coiled near the bottom bracket.
Cause: Cables fray from rust and wear, or they get thrown off the drum when a spring breaks. Moisture around the bottom of the door speeds corrosion.
DIY or pro: Pro. Cables are tied directly into the spring system.
Typical cost: $150 to $300 for both cables replaced together.
5. Opener problems (remote, motor, or gear)
Symptoms: The motor hums but the door does not move, the remote works only up close, the opener runs but the chain or belt does not, or nothing happens at all.
Cause: A stripped plastic drive gear, a failed logic board, a worn trolley, a dead remote battery, or a tripped circuit. After a Houston power surge, logic boards fail more often than you might expect.
DIY or pro: Partly DIY. Check the remote battery, the wall button, and the breaker first. Anything inside the motor housing is a pro job.
Typical cost: $150 to $300 for common component repairs; $400 to $650 for a new opener installed.
6. Door off its tracks
Symptoms: The door is visibly crooked, jammed partway, or one set of rollers has popped out of the track. There may be a bent or dented track section.
Cause: A vehicle bump, a broken cable, loose track bolts, or an obstruction in the track. Once a roller leaves the track, the door can bind and twist.
DIY or pro: Pro. Do not try to operate the opener; it can make the damage much worse. Unplug the opener and wait for a technician.
Typical cost: $150 to $500, depending on whether the track needs straightening or replacement.
7. Damaged or dented panels
Symptoms: A visible dent, crack, or bowed section, often after a vehicle tap, a basketball, or wind-driven debris during a storm.
Cause: Impact damage, or in older doors, rust and delamination from years of humidity.
DIY or pro: Pro. Panel replacement requires disconnecting the door from the springs and matching the section to your model.
Typical cost: $300 to $900 per panel. If several panels are damaged or the model is discontinued, a new door may be the better value.
8. Worn weather seal and noisy hardware
Symptoms: Daylight under the door, water or pests getting in, squeaking and rattling with every cycle.
Cause: The rubber bottom seal cracks in the sun, hinges loosen, and dry hardware grinds. In Houston, this one also affects your energy bill since hot, humid air flows freely into the garage.
DIY or pro: Mostly DIY. Replace the bottom seal with a matching profile and lubricate hinges, rollers, and springs with a garage door lubricant (never WD-40). Tightening hardware is safe as long as you leave the spring hardware alone.
Typical cost: $20 to $50 in supplies for DIY; $100 to $200 for a professional seal replacement and tune-up.
Not sure which of these you are dealing with? Call 713-598-3837 (Houston) or 281-800-5387 (Clear Lake), or request a free quote.
Frequently asked questions
What is the single most common garage door repair?
Broken torsion springs. Every door has them, every spring has a finite life, and Houston’s climate shortens that life. If your door is more than 7 years old and has never had the springs replaced, you are likely approaching that point.
Can I use my garage door with a broken spring if I lift it manually?
We strongly advise against it. A double door can weigh over 200 pounds without the spring’s help, and it can come down fast. Keep the door closed and call for service.
How do I know if a problem is the opener or the door?
Pull the red emergency release cord and lift the door by hand. If it moves smoothly and stays open at waist height, the door and springs are fine and the problem is the opener. If it is heavy, crooked, or will not move, the issue is in the door hardware.
Will a tune-up prevent most of these problems?
Not all of them, but an annual inspection catches frayed cables, worn rollers, loose hardware, and springs nearing the end of their life before they fail at the worst possible time.
Related guides
Get same-day garage door repair in Houston
Whatever the problem, BBM Garage Doors can diagnose it and fix it the same day in most cases, with 24/7 emergency service across Houston, Clear Lake, Katy, Cypress, Spring, The Woodlands, Pearland, Sugar Land, League City, and nearby communities. Call 713-598-3837 (Houston) or 281-800-5387 (Clear Lake), or see our garage door repair services.